 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Ansys Fluent Meshing Problem: Conflicting zone names |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 8, 2016, 11:41
|
Ansys Fluent Meshing Problem: Conflicting zone names
|
#1 |
|
New Member
Ontario
Join Date: Nov 2016
Posts: 4
Rep Power: 10  |
I used Mirror to duplicate my original geometry in DesignModeler. When I tried to mesh the geometry, there was an error:' The mesh translation to Fluent failed due to conflicting zone names'. I didn't rename any zone.
I really don't know what cause this error! Thanks ! |
|
|
|
|
|
November 14, 2016, 02:59
|
|
#2 |
|
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 23 |
This is because all the zones in your model are named 'solid'. You can change them to solid1, solid2... and so on and try again.
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem using ANSYS Fluent 15.07 | Saikat_FM | FLUENT | 2 | July 13, 2015 06:10 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 09:42 |
| Fluent incident radiation problem | Michael Schwarz | Main CFD Forum | 0 | October 21, 1999 06:56 |
Linear Mode
