[ICEM] problem with meshing 2d airfoil

puppypuppygo · October 29, 2016, 06:00

When I mesh a domain of 2D airfoil, some errors occurs.
I set the unit to "meter", and the chord length of the airfoil is 1m. Then I set the maximum size of the wall of airfoil to 0.0001m. But the airfoil was ignored.
When I set the maximum size of the wall of airfoil to 0.001m, it was meshed correctly.
Why did this happened? I couldn't find the reason now.
Thanks for anyone who can help me with this problem, thank you

ignored.jpg

ignored_2.jpg

max_size_setup.jpg

correct.jpg

max_size_setup_2.jpg

shereez234 · November 4, 2016, 09:00

If i were you I would do blocked structured mesh rather than this approach

Gweher · November 4, 2016, 09:08

As Shereez said you'll be way more efficient using a blocking strategy. This is well documented, you can even find a nice tutorial that Simon made some time ago : https://www.youtube.com/watch?v=tYrbScUH9RE

October 29, 2016, 06:00	problem with meshing 2d airfoil	#1
puppypuppygo New Member Ding Ding Join Date: Oct 2016 Posts: 1 Rep Power: 0	When I mesh a domain of 2D airfoil, some errors occurs. I set the unit to "meter", and the chord length of the airfoil is 1m. Then I set the maximum size of the wall of airfoil to 0.0001m. But the airfoil was ignored. When I set the maximum size of the wall of airfoil to 0.001m, it was meshed correctly. Why did this happened? I couldn't find the reason now. Thanks for anyone who can help me with this problem, thank youignored.jpg ignored_2.jpg max_size_setup.jpg correct.jpg max_size_setup_2.jpg

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with querying the meshing database in CFX-Pre	ashtonJ	CFX	18	April 19, 2023 00:49
High drag for airfoil compared to XFOIL and wind tunnel data	Ry10	SU2	15	October 30, 2016 18:27
Problem with restart solution in shape_optimization.py	robyTKD	SU2 Shape Design	21	May 29, 2013 10:26
[GAMBIT] meshing trailing airfoil	carp	ANSYS Meshing & Geometry	4	March 20, 2013 02:12
[Other] Ansys meshing airfoil and / or compressor blades	baw192	ANSYS Meshing & Geometry	8	September 23, 2011 01:43

November 4, 2016, 09:00		#2
shereez234 Senior Member M Sereez Join Date: Jan 2014 Location: England Posts: 353 Blog Entries: 1 Rep Power: 13	If i were you I would do blocked structured mesh rather than this approach

November 4, 2016, 09:08		#3
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	As Shereez said you'll be way more efficient using a blocking strategy. This is well documented, you can even find a nice tutorial that Simon made some time ago : https://www.youtube.com/watch?v=tYrbScUH9RE