[ICEM] profile data -- CFD Online Discussion Forums

September 18, 2016, 04:13	profile data	#1
svaezi New Member Join Date: May 2015 Posts: 11 Rep Power: 11	Hi every body I am simulating solar chimney , firstly i set 22c for uniform inlet temperature but when i saw the result in cfd post, temperature was not uniform. because of this i have to use profile data. i have question about making profile data in 3d when your surface is periodic and if i set temperature just in one line( my line in picture), is this correct or not??? my profile data and picture of solar chimney are attached. thanks so much.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] 2 datas on one plot	Akuji	ParaView	46	December 1, 2013 15:06
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 11:52
Inlet profile from 2D velocity and turbulence data	Attesz	OpenFOAM Pre-Processing	2	March 11, 2012 07:09
Error reading profile data	dirk	FLUENT	1	August 31, 2005 22:36
CFXSolver Error Message using Profile Data on B	Tobias	CFX	0	August 26, 2005 08:27

All times are GMT -4. The time now is 16:04.