 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Problem with Inflation Layer on Cut Cell Mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 22, 2016, 09:44
|
Problem with Inflation Layer on Cut Cell Mesh
|
#1 |
|
Senior Member
Join Date: Aug 2014
Location: Germany
Posts: 292
Rep Power: 14  |
Hello,
i meshed my three part geometry with the assembly meshing tool. However i did not achieve a conformal inflation layer between my three geometry parts. The inflation layer bends between these areas, i want the same thickness etc. for the prism layer for all three connected parts (see atached picture) How do i do that?  thanks |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 20:34 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| [snappyHexMesh] Very BIG problem with snappy | Yuby | OpenFOAM Meshing & Mesh Conversion | 1 | April 30, 2015 16:53 |
| [snappyHexMesh] Snapping problem, non orthogonal faces | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2015 03:56 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 14:20 |
Linear Mode
