 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Failed to select lines to make projections in 2D: Design Modeler |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 9, 2016, 20:02
|
Failed to select lines to make projections in 2D: Design Modeler
|
#1 |
|
New Member
Henrique José
Join Date: Jun 2016
Posts: 2
Rep Power: 0  |
Hi everybody,
I am trying to simulate the flow around a foil with a flap an I made the geometry in ANSYS Design Modeler in a Student License. Close to the end of the geometry, I did some lines in order to have a structured mesh. But when I tryed to select the lines to be the edges of the projection, I did not succeed. I can´t select the lines at all. I have attached a word document containing some pictures of the foil and the lines I am trying to select. So, if anybody knows what can be happening, I will be very gratefull. Thanks a lot!! Henrique. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error with boolean subtract in Design Modeler | mattK | FLUENT | 6 | March 12, 2018 11:23 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 05:26 |
| OpenFOAM with IBM AIX | matthias | OpenFOAM Installation | 20 | March 25, 2008 03:36 |
| Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 04:39 |
| user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 07:31 |
Linear Mode
