[DesignModeler] Difficulty in 3D curve generation

brmr · May 2, 2016, 11:46

Hi there,

I am currently working on school project and i kinda new to ansys. I am trying to generate RAE 2822 Aerofoil from the below data points. But i keep getting the error of "self intersecting geometry" Can anyone suggest where i am doing it wrong? I have tried replacing "," with "." but it doesn't work. Thanks in advance.

Regards.

jrunsten · May 3, 2016, 06:23

You need to reorder some things I think. Look at the jump in x coordinate between point 64 and 65. I think you need to have them in a continous loop around the airfoil and not segmented like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 11:49
meshing of a compound volume in GMSH	shawn3531	OpenFOAM	4	March 12, 2015 11:45
CFX4.3 -build analysis form	Chie Min	CFX	5	July 13, 2001 00:19
Latest new in mesh generation	Robert Schneiders	Main CFD Forum	0	February 16, 2000 08:12
Latest news in mesh generation	Robert Schneiders	Main CFD Forum	0	March 2, 1999 05:07

May 3, 2016, 06:23		#2
jrunsten Senior Member Josef Runsten Join Date: Jul 2010 Location: Gothenburg, Sweden Posts: 188 Rep Power: 24	You need to reorder some things I think. Look at the jump in x coordinate between point 64 and 65. I think you need to have them in a continous loop around the airfoil and not segmented like this.