 |
 |
 |
|
|
|
[Sponsors] | ||||
April 4, 2016, 07:43
|
ICEM CFD Interface meshing problem
|
#1 |
|
New Member
Join Date: Sep 2014
Posts: 9
Rep Power: 12  |
Hi. I try to mesh model which is constructed from 2 fluid zones.
1 zone is triangles and 2 zone is hexa. Problem accrues at interface zone when 2 mesh lines intersect. One interface line is perfect, but another line which is shown at picture below have voids. Maybe someone can help me with solution ? I need to create good interface zone. 
|
|
|
|
|
|
December 12, 2016, 04:41
|
|
#2 |
|
New Member
Roya.TR
Join Date: Feb 2014
Posts: 9
Rep Power: 12 |
hi
in ansys mesh you can solve this problem you should creat a new part from all your parts in ansys modeler by these steps: ain ansys modeler => right click on parts and select them and take them as new part good luck and sorry for my bad english writing 
|
|
|
|
|
|
 |
| Tags |
| cfd, icem, interface, interface problem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] SHIP MESHING * using ansys WORKBENCH or ICEM CFD | Ctunramran | ANSYS Meshing & Geometry | 1 | February 23, 2016 08:06 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 07:28 |
| [ANSYS Meshing] Meshing problem using ICEM CFD | cgpa4 | ANSYS Meshing & Geometry | 2 | November 4, 2012 13:22 |
| Icem CFD Meshing Problem | eRzBeNgEl | ANSYS | 1 | January 20, 2011 08:55 |
| [ICEM] Need help in ICEM CFD Mapped Meshing | falconf16 | ANSYS Meshing & Geometry | 3 | February 19, 2010 15:21 |
Linear Mode
