 |
 |
 |
|
|
|
[Sponsors] | ||||
March 25, 2016, 05:20
|
corrugated plate
|
#1 |
|
New Member
Asal
Join Date: Jan 2016
Location: Belgium
Posts: 5
Rep Power: 10  |
Dear all,
I am trying to mesh a 3D geometry with 2 corrugated plate stacked on each other. I need to have fine mesh with boundary layer. However because of the sharp angles the quality mesh drops down for some elements. I have tried multi zone mesh and tetrahedron but the quality is not good. I would appreciate if someone can help me with this. Thanks a lot, Asal |
|
|
|
|
|
March 29, 2016, 04:46
|
|
#2 |
|
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 23 |
Both the parts look sweepable, I recommend that you try sweep mesh.
|
|
|
|
|
|
 |
| Tags |
| 3d corrugated plate, ansys meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| corrugated passes plate in rotary regenerative air preheater | nuengao | FLUENT | 2 | March 8, 2021 14:21 |
| pimpleDyMFoam - harmonic motion of a plate - wrong pressure distribution | adii | OpenFOAM | 0 | April 30, 2014 09:28 |
| HELP! Flow over both sides of a plate. | farocean97 | Main CFD Forum | 0 | September 12, 2011 11:57 |
| heat transfer on dimpled plate | mech | FLUENT | 4 | February 6, 2007 16:15 |
| Parallel Plate Rheometer vs Cone & Plate | beginner | Main CFD Forum | 0 | March 19, 2003 12:49 |
Linear Mode
