 |
 |
 |
|
|
|
[Sponsors] | ||||
[TurboGrid] Importing blade point cloud into turbogrid |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 18, 2016, 05:56
|
Importing blade point cloud into turbogrid
|
#1 |
|
Member
Jack
Join Date: May 2015
Posts: 98
Rep Power: 11  |
Hi all!
I am designing a 3D blade in matlab which outputs sections of the blade at positions of constant radius in the form of 3D point coordinates. I would like to use this point cloud as input to the Turbogrid mesher to get a highquality mesh for CFD analysis. Is this possible and if so how do I make this work? Thanks! |
|
|
|
|
|
| Tags |
| ansys, turbogrid |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compressor Blade Analysis in Ansys CFX | LynchMobster47 | Main CFD Forum | 0 | April 10, 2012 23:43 |
| Axial blade simulation, TurboGrid a must? | Gentry | CFX | 1 | March 19, 2009 11:20 |
| Setting up a point monitor rotating with the blade | Hamidur | CFX | 1 | September 13, 2008 18:00 |
| Point cloud data | ms | Main CFD Forum | 1 | July 25, 2006 17:54 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
