[ANSYS Meshing] Overlapping Named Selection error though every named selection differs from each othe

Onurozcan · December 7, 2015, 14:25

Hi,

I am working on 3D heat exchanger flow fluid analysis.

on photo below I have uploaded is relevant to overlapping name selection that I have never made same named selection in same geometry face/edge/vertex

How could it possibly to happen even if I could not give any same named selection?

Moreover all tubes have been picked up together and all tubes is intersection to outer region that I make design

Thanks in Advance

https://imageshack.com/i/paX0frrbp

Kapi · December 10, 2015, 22:49

seems you have used same face or edges in two different named selection.
Check your named selection one by one and see which two named selection highlights this face/edge! remove it form one or other named selection!!

sorted!

cheers
KAPI

December 7, 2015, 14:25	Overlapping Named Selection error though every named selection differs from each othe	#1
Onurozcan Member Onur Join Date: Sep 2015 Posts: 42 Rep Power: 11	Hi, I am working on 3D heat exchanger flow fluid analysis. on photo below I have uploaded is relevant to overlapping name selection that I have never made same named selection in same geometry face/edge/vertex How could it possibly to happen even if I could not give any same named selection? Moreover all tubes have been picked up together and all tubes is intersection to outer region that I make design Thanks in Advance https://imageshack.com/i/paX0frrbp

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
y+ and u+ values with low-Re RANS turbulence models: utility + testcase	florian_krause	OpenFOAM	114	August 23, 2023 06:37
Near wall treatment in k-omega SST	Arnoldinho	OpenFOAM Running, Solving & CFD	38	March 8, 2017 14:48
[OpenFOAM] Native ParaView Reader Bugs	tj22	ParaView	270	January 4, 2016 12:39
Overlapping Named Selection error though every named selection differs from each othe	Onurozcan	Main CFD Forum	0	December 6, 2015 17:12
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 21:50

December 10, 2015, 22:49		#2
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	seems you have used same face or edges in two different named selection. Check your named selection one by one and see which two named selection highlights this face/edge! remove it form one or other named selection!! sorted! cheers KAPI