[ANSYS Meshing] Crazy Surface Mesh

RodriguezFatz · December 2, 2015, 05:32

Hi all,
I have a problem with a part of my geometry that is imported from CAD.
I cutted the geometry in different bodies, one of them looks like a cylinder. For some reason, meshing doesn't recognize it as "sweepable", but that doesn't matter here, although this is suspicious and might be a hint to the solution. Anyway, the surface mesh of that body looks horrible and I have no idea how to get it better.

Here, have a look.
bad_mesh_1.png
bad_mesh_2.png
Do you have any idea what could be the reason for this?
This is "patch conforming", but I need it because I want to use pre-inflation. If I set it t "patch independent" the mesh looks fine.

I do not need to get it sweepable, because I want to have different edge resolutions on both sides.

RodriguezFatz · December 2, 2015, 06:15

Ok, if I switch off "advanced sizing function" the mesh looks fine. But I need it at other parts...
Any other setting (on: fixed, on:curvature,...) leads to the bad mesh.

December 2, 2015, 05:32	Crazy Surface Mesh	#1
RodriguezFatz Senior Member Philipp Join Date: Jun 2011 Location: Germany Posts: 1,297 Rep Power: 27	Hi all, I have a problem with a part of my geometry that is imported from CAD. I cutted the geometry in different bodies, one of them looks like a cylinder. For some reason, meshing doesn't recognize it as "sweepable", but that doesn't matter here, although this is suspicious and might be a hint to the solution. Anyway, the surface mesh of that body looks horrible and I have no idea how to get it better. Here, have a look. bad_mesh_1.png bad_mesh_2.png Do you have any idea what could be the reason for this? This is "patch conforming", but I need it because I want to use pre-inflation. If I set it t "patch independent" the mesh looks fine. I do not need to get it sweepable, because I want to have different edge resolutions on both sides. __________________ The skeleton ran out of shampoo in the shower.

December 2, 2015, 06:15		#2
RodriguezFatz Senior Member Philipp Join Date: Jun 2011 Location: Germany Posts: 1,297 Rep Power: 27	Ok, if I switch off "advanced sizing function" the mesh looks fine. But I need it at other parts... Any other setting (on: fixed, on:curvature,...) leads to the bad mesh. __________________ The skeleton ran out of shampoo in the shower.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 12:05
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry	pizzaspinate	OpenFOAM Meshing & Mesh Conversion	1	February 25, 2015 08:05
[snappyHexMesh] Problem with Sanpper, surface still Rough	Zephiro88	OpenFOAM Meshing & Mesh Conversion	7	November 5, 2014 13:05
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 22:11