 |
 |
 |
|
|
|
[Sponsors] | ||||
November 26, 2015, 11:51
|
Interior Face Problem
|
#1 |
|
New Member
Join Date: Oct 2015
Posts: 24
Rep Power: 11  |
Hello everyone. I'm meshing fuel cell with ICEM.There are solid-fluid-fluid-fluid-fluid-fluid-fluid-solid bodies from top to bottom.There are two problems at the faces between the fluid bodies.First of all,after meshing the faces which I mentioned before are become wall instead of interior. Secondly and the most problematic issue,after meshing ICEM splits interior surfaces randomly.For example, one of the face between the fluid parts splits three or four surfaces however it should be only one surface.How can I overcome my problems?
|
|
|
|
|
 |
| Tags |
| interior faces |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 05:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 06:59 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 15:52 |
Linear Mode
