[ICEM] Problem in solid mesh at ICEM CFD HEXA 3D Elbow Tutorial

sajjad7 · October 15, 2015, 22:03

Hi,
I'm just learning ICEM CFD and concepts of meshing.
I have done first few tutorials of ICEM.
In the elbow tutorial, after doing the routines, I tried to mesh the solid but some weird behaviors happened. In middle block, the grid are just as I expected but in the top and the bottom ones, the mesh grids just act weird!
For example, from the middle block to bottom, the grids have a tendency to move to the CYL edges!
I tried to re-associate the edges (all exactly the same to he tutorial) but nothing!
Even playing with Surface association, moving vertices, ... bring no help.

I saw the youtube tutorial and recheck the tutorials script but no one mentioned the solid mesh !
Could anyone help me what is the problem?

You may find in the attachment the picture of what I am trying to say!
The cut plane is "Middle Z".

And as a beginner, I really cannot explain very well about the situation I am facing, then maybe attaching the .blk and .tin of my saved project can help.

Regards
Sajjad

sajjad7 · October 16, 2015, 06:46

Hi,

I found the problem. Actually the "SOLID" name tricked me!
At first I thought that the part is a closed volume but after closer look I found that the small cylinder has no surface on its top and bottom! and the pre-mesh trying to converge all the grids to the top and bottom edge.
After adding the two surfaces the problem was gone.

Thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Import Mesh from ICEM CFD to CFX	Andre Almeida	CFX	16	April 19, 2016 04:42
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
ICEM hexa mesh tutarial 2d car problem	cfduser	CFX	2	March 9, 2008 10:40
ICEM hexa mesh tutarial 2d car problem	cfduser	FLUENT	0	March 8, 2008 17:16
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 20:04

October 16, 2015, 06:46		#2
sajjad7 New Member sajjad Join Date: Nov 2014 Posts: 3 Rep Power: 11	Hi, I found the problem. Actually the "SOLID" name tricked me! At first I thought that the part is a closed volume but after closer look I found that the small cylinder has no surface on its top and bottom! and the pre-mesh trying to converge all the grids to the top and bottom edge. After adding the two surfaces the problem was gone. Thanks.