 |
 |
 |
|
|
|
[Sponsors] | ||||
September 25, 2015, 09:18
|
Ansys Bridge Modelling
|
#1 |
|
New Member
Mousa Dahabreh
Join Date: Sep 2015
Posts: 5
Rep Power: 11  |
file3.png
Hi all, Shouldn't I be getting tension in the bridge deck as well rather than just in Hangers/Cables? As that's how an arch bridge works. I am 85% sure this is not a connection error as the mesh/nodes seems completely fine. Also, I've created each single small line separately so there shouldn't be a problem. Any input/help is highly appreciated. Thank you, Mousa |
|
|
|
|
 |
| Tags |
| ansys workbench, arch bridges, bridge design, modelling, structural analysis |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Command Line Run for ANSYS | Liaquat | ANSYS | 11 | April 19, 2018 10:49 |
| Modelling of a composite and drilling simulation in ansys | Melliesons | Structural Mechanics | 0 | March 31, 2015 11:57 |
| Bridge ANSYS and paraview | sanjar | OpenFOAM Running, Solving & CFD | 2 | March 19, 2014 21:42 |
| Porous media modelling in ANsys | dreamlifter747 | ANSYS | 0 | September 13, 2013 11:29 |
| Problem when modeling Arch Bridge by Ansys Workbench 14.0 | tranhoa279 | ANSYS | 0 | August 30, 2013 02:29 |
Linear Mode
