 |
 |
 |
|
|
|
[Sponsors] | ||||
August 24, 2015, 09:16
|
Conformal Mesh for MRF
|
#1 |
|
New Member
Dinushke
Join Date: Aug 2013
Location: Victoria, Australia
Posts: 13
Rep Power: 13  |
Hi,
I am trying to generate a conformal mesh for a MRF simulation on Fluent, but the only way I have read up to now is that I have to enable "Shared Topology" in the part (Ansys DesignModeler). The issue that this causes it that I can't now define the shared but different surfaces that make contact, which are the stationary and rotating cylinder (Outer and inner interface), without these the Fluent won't accept the mesh. Is there any other way to gain a conformal mesh without sharing topology. |
|
|
|
|
 |
| Tags |
| conformal meshes, mrf., shared topology |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 08:34 |
| Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 07:21 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 04:52 |
| engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 14:40 |
| conformal vs. non conformal mesh | otho | Main CFD Forum | 2 | May 30, 2008 12:11 |
Linear Mode
