 |
 |
 |
|
|
|
[Sponsors] | ||||
July 16, 2015, 10:51
|
Problem by using a mesh
|
#1 |
|
Member
Hamidreza Bijanyar
Join Date: Jun 2015
Posts: 40
Rep Power: 11  |
Hello,
I have a mesh file in .meshdat format. When i open it in Ansys Workbench 16.1 in coordinate system part there is some problem : coordinate system ---->origin ---->define by This should be on global coordinate but it is on geometry selection. When i change it ti correct one mesh part tell that it require to update. When i Update the mesh , new generated mesh is not same as previous!!! Mesh statistic : Nodes : 466527 Elements : 1420981 Skewness : 3.2266e-005 ---091823 But the re generated mesh has some other statistic. How can i happen ?? What is wrong ?? My simulation convergence with first mesh but don't in second one! I attached 4 picture from what i am telling ! pic 1 -->Coordinate system Problem pic 2 -->Coordinate system correction pic 3 -->First mesh statistic pic 4 -->New generated mesh statistic |
|
|
|
|
|
July 17, 2015, 03:00
|
|
#2 |
|
Member
Hamidreza Bijanyar
Join Date: Jun 2015
Posts: 40
Rep Power: 11 |
No one Knows ??
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 05:27 |
| Gambit problems | Althea | FLUENT | 22 | January 4, 2017 04:19 |
| Overset MESH problem DFBI 6DOF | Ale85 | STAR-CCM+ | 0 | October 1, 2013 13:25 |
| [ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 11:06 |
| [GAMBIT] SOFC crossflow mesh possible problem??? | epc1 | ANSYS Meshing & Geometry | 1 | February 4, 2013 02:57 |
Linear Mode
