[Workbench] Problems importing ICEM Mesh -- CFD Online Discussion Forums

July 15, 2015, 05:34

Problems importing ICEM Mesh

pizzaspinate

Member

Join Date: Dec 2012

Posts: 81

Rep Power: 14

Hey there,
I have meshed my geometry in ICEM and loaded it into CFD. However, I get funny cells (as shown in the picture). Does anyone know what causes this? I have run check Mesh in ICEM and it said everything is fine.

Thank you very much in advance for your help

Attached Images

ANSYS_error.jpg (24.9 KB, 2 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trouble with importing intricate block-structured mesh from ICEM to Fluent	highhopes	FLUENT	0	February 22, 2015 15:02
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent	sonic109	ANSYS Meshing & Geometry	2	September 3, 2014 01:56
[Commercial meshers] ansys icem tetra mesh to fluent_v6 conversion problems	milleniumrider	OpenFOAM Meshing & Mesh Conversion	3	May 13, 2010 15:54
Problems with importing ICEM-CFD mesh in CFX	signofra	CFX	3	March 3, 2010 11:08
Importing a mesh from ICEM	Waseem Siddique	Siemens	14	February 9, 2009 06:05

All times are GMT -4. The time now is 17:56.