[ANSYS Meshing] Transition from coarse to fine mesh -- CFD Online Discussion Forums

June 29, 2015, 14:35

Transition from coarse to fine mesh

Shruti

New Member

Join Date: Apr 2015

Posts: 8

Rep Power: 11

Hi all,

I want to know if it is possible to go from fine mesh to coarse mesh as shown in the images below while creating a mesh through blocking technique in icemcfd. (These images are from truegrid website, http://www.truegrid.com/Transition.html). I have searched a lot but couldn't find such an option in icemcfd.

Attached Images

	trbb3.jpg (57.7 KB, 13 views)
	cvat6z.jpg (28.1 KB, 13 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solving After Mapping Fields	sohailr	OpenFOAM Pre-Processing	2	April 6, 2014 15:52
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42
From a fine to a coarse mesh	Nereus	Main CFD Forum	0	June 11, 2012 10:57
[snappyHexMesh] How to generate a coarse mesh with snappyHexmesh	laplacian	OpenFOAM Meshing & Mesh Conversion	0	June 30, 2011 11:41
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 19:10

All times are GMT -4. The time now is 19:58.