 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Inflation Layer Meshing around a Corner of two different connected Geometry |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 2, 2015, 06:33
|
Inflation Layer Meshing around a Corner of two different connected Geometry
|
#1 |
|
New Member
Anton Hilfer
Join Date: Dec 2014
Posts: 7
Rep Power: 12  |
Hey Guys,
i have a small problem in Ansys Meshing with the generation of inflation Layers around the corner of different Parts. Like in the picture ... Does anyone have a proposal how to create a continuos Inflation Layer around the Corner? |
|
|
|
|
|
June 2, 2015, 09:30
|
|
#2 |
|
Senior Member
Josef Runsten
Join Date: Jul 2010
Location: Gothenburg, Sweden
Posts: 188
Rep Power: 24  |
Join the two bodies if possible
Create > Boolean > Operation: Unite |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 06:53 |
| [snappyHexMesh] meshing of very small patches in comparison with the overall geometry | christos | OpenFOAM Meshing & Mesh Conversion | 3 | December 17, 2014 17:55 |
| [snappyHexMesh] Meshing NACA airFoil with snappy | Paolo.F | OpenFOAM Meshing & Mesh Conversion | 6 | October 8, 2013 05:52 |
| [snappyHexMesh] Meshing of A380 | Mirage12 | OpenFOAM Meshing & Mesh Conversion | 4 | September 4, 2013 00:27 |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 05:25 |
Linear Mode
