[ICEM] BLOCKING STRATEGY FOR A Vertical Axis wind Turbine

bose.sumantraa · May 5, 2015, 10:29

Dear all,

I am quite new to ICEM CFD. I would like to study the flow around a h-type darrieus VAWT in a wind tunnel. I saw some tutorials on blocking aerofoil in 3d too. Can someone guide me on how to do blocking for the blades and central shaft in 3d? The model looks similar to the image in the link below.

Thanks.

SeanO'H · October 4, 2016, 08:00

Hi.

I am just wondering if you were able to figure out a suitable blocking strategy for the 3D VAWT? I've been able to generate meshes for a single aerofoil and also for the rotating domain. But when I try to combine the two I am having issues?

Thanks

May 5, 2015, 10:29	BLOCKING STRATEGY FOR A Vertical Axis wind Turbine	#1
bose.sumantraa New Member sumatra Join Date: Nov 2014 Location: Chennai Posts: 1 Rep Power: 0	Dear all, I am quite new to ICEM CFD. I would like to study the flow around a h-type darrieus VAWT in a wind tunnel. I saw some tutorials on blocking aerofoil in 3d too. Can someone guide me on how to do blocking for the blades and central shaft in 3d? The model looks similar to the image in the link below. Thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] question about Blocking a full scale vertical axis wind turbine	mohsen razavi	ANSYS Meshing & Geometry	0	February 24, 2015 07:11
Vertical Axis Wind Turbine	atorninc	Main CFD Forum	3	March 6, 2013 05:38
Vertical Axis Wind Turbine Rotating Domain Problems	TWaung	CFX	4	May 1, 2012 04:14
Reversed flow in Vertical axis wind turbine	Anonymized_JL1	FLUENT	2	April 11, 2012 04:13
Vertical axis wind turbine in NUMECA	ArslanOZCAN	Fidelity CFD	2	July 21, 2011 06:04

October 4, 2016, 08:00		#2
SeanO'H New Member Sean o'hEimhigh Join Date: Jan 2015 Posts: 2 Rep Power: 0	Hi. I am just wondering if you were able to figure out a suitable blocking strategy for the 3D VAWT? I've been able to generate meshes for a single aerofoil and also for the rotating domain. But when I try to combine the two I am having issues? Thanks