 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Inflation layer near gap with multizone mesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 24, 2015, 10:32
|
Inflation layer near gap with multizone mesh
|
#1 |
|
New Member
Join Date: Dec 2014
Posts: 9
Rep Power: 12  |
Hello,
I try to mesh an airfoil section with two components. The wing and the flap. The problem is the gap between the two parts. How can I create a flexible Inflation layer, which is able to align when its moving to the gap? I have tested this mesh with a tetra grid, then the prismlayer is adapting when it comes closer to the gap! But this does not work when I use Prism or Hex elements for a structured grid. The Inflation is neccesary for high resolution at the wall,because I decided to use SST turbulence model. Any help is thankfully welcome. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] problems generating clean mesh | Christian_tt | OpenFOAM Meshing & Mesh Conversion | 2 | June 20, 2019 06:39 |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 09:07 |
| [snappyHexMesh] snappyHexMesh Boundary Layer at Corner | panpanzhong | OpenFOAM Meshing & Mesh Conversion | 5 | July 3, 2018 06:53 |
| [snappyHexMesh] snappy hangs while layer generation | bastil | OpenFOAM Meshing & Mesh Conversion | 3 | October 29, 2010 08:19 |
| [snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 14:47 |
Linear Mode
