 |
 |
 |
|
|
|
[Sponsors] | ||||
February 18, 2015, 01:01
|
Cannot see Prism layers
|
#1 |
|
Member
Hassan Iftekhar
Join Date: Jan 2015
Posts: 40
Rep Power: 11  |
I am unable to draw prism layers.
 I checked off the prism layers in part mesh setup. And re meshed the entire mesh using compute mesh/prims mesh. Defined prism 1st height length in global mesh setup. But still I cannot see prism layers on walls and ground. My 1st layer height is 0.14 and total height Is 3.645 mm. ratio is 1.2. Comments are really appreciated. 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Prism layers and grid dependence study | jcamilleri | STAR-CCM+ | 4 | July 7, 2014 14:47 |
| Trimmed Cell Mesher and Prism Layers | Jack220 | STAR-CCM+ | 4 | August 7, 2013 11:57 |
| [ICEM] Large elements after creating prism layers | khoopes | ANSYS Meshing & Geometry | 4 | June 17, 2013 14:05 |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 08:06 |
| ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 15:56 |
Linear Mode
