|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Saiteja
Join Date: Aug 2014
Posts: 13
Rep Power: 12 ![]() |
Hello
I have imported a mesh file in stl format which is the prfect surface mesh I require. i just need to create a volume mesh (a spherical farfield) around it. When I do so and start meshing the farfield the imported stl file automatically vanishes. I did see few threads regarding build topology etc for a similar question. But my grid topology option is not even highlighted since I import as a mesh. If I import as geometry I will not be able to have the same mesh as in the stl file and also I need to remesh entirely. Could some one give a solution to this problem? Note: You can suggest me if any other mesh formats are compatible for my requirement!! |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] Patches to compile OpenFOAM 2.2 on Mac OS X | gschaider | OpenFOAM Installation | 136 | October 10, 2017 17:25 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
[swak4Foam] Error bulding swak4Foam | sfigato | OpenFOAM Community Contributions | 18 | August 22, 2013 12:41 |
[swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |