 |
 |
 |
|
|
|
[Sponsors] | ||||
January 13, 2015, 10:43
|
Quarter O-Grid: Blocking/Meshing-Tips
|
#1 |
|
Member
MB
Join Date: Sep 2012
Posts: 30
Rep Power: 14  |
Hello everybody,
I'm trying to mesh a cylindrical pipe with a needle (injector) inside. Attached you can find my geometry. I'm planning to do a quarter-mesh with two symmetry-planes (green and orange in the picture). What is the best way to do the connection between the pipe without the needle (L-grid) and the pipe with the needle, any suggestions? Thanks a lot! |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Some questions about unstructured grid. | Yanci | OpenFOAM Meshing & Mesh Conversion | 1 | November 28, 2014 11:47 |
| [ICEM] Double Y grid and single Y grid | brissyben | ANSYS Meshing & Geometry | 5 | July 27, 2009 10:24 |
| Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 14:18 |
| GRID TO GRID INTERPOLATION in FLUENT | calogero | FLUENT | 3 | June 4, 2003 09:32 |
| Numerical methods for discontinuous grid interfaces? | Hansong Hang | Main CFD Forum | 12 | September 16, 1998 23:26 |
Linear Mode
