 |
 |
 |
|
|
|
[Sponsors] | ||||
December 22, 2014, 07:18
|
Merging the mesh
|
#1 |
|
New Member
Kumari
Join Date: Nov 2014
Posts: 1
Rep Power: 0  |
Hi everyone!
I have tried merging meshes in ICEMCFD and have attained my final mesh. But I'm not sure whether it is a valid way of doing and it's also read by fluent without error or warning. The steps followed are 1. I've loaded my .uns files one by one. 2. Clicked on merge instead of replace. 3.Finally, it was saved followed by applying BC and writing the input file. Prompt me, if I'm wrong and tell me the right way of doing it. As I need non conformal mesh, I don't have any more issues as matching other than merging components. Last edited by KumariSurya; December 23, 2014 at 02:01. |
|
|
|
|
 |
| Tags |
| icem cfd 14.5, merge mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 08:34 |
| [snappyHexMesh] problems generating clean mesh | Christian_tt | OpenFOAM Meshing & Mesh Conversion | 2 | June 20, 2019 06:39 |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 01:27 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
Linear Mode
