[bgp723]

Hello,

I am running ICEM CFD 14.5 using matlab.
I create a ICEM CFD replay script using matlab with the command
eval(['! icemcfd -batch -script ' MyDir '/GeoMeshScript.rpl']), which allows me to execute ICEMCFD.
Everytime I use batch mode, I get this error message everytime:

Usage split_grid node dim val [ dim:min,max ] [ m m1 m2 ... ] [ marked ]
Usage split_grid node dim val [ dim:min,max ] [ m m1 m2 ... ] [ marked ]
while executing
"hexlib_interface__574 split_grid 21 25 GEOM.74 m GEOM GEOM_FLUID SOLID FLUID INLET OUTLET INT-PRESS-IN INT-PRESS-OUT CONTACT-REGION SYM-INLET SYM-OUTL..."
("eval" body line 1)
invoked from within
"eval $hexlib split_grid $args"
(procedure "ic_hex_split_grid" line 15)
invoked from within
"ic_hex_split_grid 21 25 GEOM.74 m GEOM GEOM_FLUID SOLID FLUID INLET OUTLET INT-PRESS-IN INT-PRESS-OUT CONTACT-REGION SYM-INLET SYM-OUTLET SYM-FIN SYM-..."
invoked from within
"batch_interp eval ic_hex_split_grid $args"


However, when I use interactive mode (basically change -batch to -interactive), so eval(['! icemcfd -interactive -script ' MyDir '/GeoMeshScript.rpl']),
the replay script works perfectly fine and creates the desired mesh.

I would prefer to run everything in batch instead of interactive mode because batch allows faster processing.
Please someone help me figure out this issue

Thank you