|
[Sponsors] |
[Workbench] Valve seat not aligned with valve face problem |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: Jan 2014
Posts: 5
Rep Power: 12 ![]() |
Hi,
I am working on simulation of air flow through a single cylinder 2-valve engine.I am using ANSYS Workbench IC engine module for it. I have completed the input manager part but when I go for decomposition of the geometry, a warning is displayed which says the valve seat is not aligned with the valve face. I have done the trouble shooting as given in the help file but the same warning persists. Any help would be greatly appreciated. |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic meshing of self-acting seat valve, how to control mesh event times? | DanielBeck | FLUENT | 1 | February 17, 2015 13:36 |
[General] Problem in the calculation of the normal gradient on a boundary face | N1colas | ParaView | 1 | June 28, 2013 10:38 |
[GAMBIT] Problem in link face mesh for periodic | newbie384 | ANSYS Meshing & Geometry | 1 | June 28, 2013 07:31 |
[Commercial meshers] Converting meshes that includes interfaces | ham | OpenFOAM Meshing & Mesh Conversion | 29 | January 8, 2007 09:58 |
problem related to mesh | naveen | CFX | 3 | March 25, 2006 09:47 |