[amin.z]

Hello to all

I'm modeling a turbocharger and I have a problem about 3 weeks!
as below figure I'm meshing this part and I want use match control for the 2 sides for Periodic BC! but when I try for this, the match control failed and say:

The mesher cannot find matching topology for following topology

Have you any solution for this error?
My project is failing!

[Shamoon Jamshed]

Originally Posted by amin.z

Hello to all

I'm modeling a turbocharger and I have a problem about 3 weeks!
as below figure I'm meshing this part and I want use match control for the 2 sides for Periodic BC! but when I try for this, the match control failed and say:

The mesher cannot find matching topology for following topology

Have you any solution for this error?
My project is failing!

Dear friends,

I am also getting the error
The meshing algorithm did not find matching topology....check orientation etc.

Please help