[ANSYS Meshing] Bad Mesh at Volute-edges -- CFD Online Discussion Forums

May 28, 2014, 06:29

Bad Mesh at Volute-edges

Daniel Frederik

Member

Daniel Frederik

Join Date: Apr 2014

Location: Switzerland

Posts: 38

Rep Power: 12

Daniel Frederik is on a distinguished road

Hi,

I'm meshing a volute, the mesh doesn't respect very well the edges. In the pictures it shows how the elements don't follow the edge at the Inlet. What can I do here?

Thank you in advance

Attached Images

Inlet_fail.PNG (25.2 KB, 15 views)

May 28, 2014, 10:59		#2
Daniel Frederik Member Daniel Frederik Join Date: Apr 2014 Location: Switzerland Posts: 38 Rep Power: 12	I just found the answer to the problem. Decresing the Topology Tolerance helped.

May 28, 2014, 13:56		#3
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 29	for me it looks like there is no edge between the two surfaces, make sure they are not dormant or deleted __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 09:54
How to improve bad Volume Mesh in Edges	renee	STAR-CCM+	4	January 3, 2014 09:29
[ICEM] Checking the mesh -> problem of single edges	Clecl	ANSYS Meshing & Geometry	21	September 24, 2012 05:04
engrid -> save as .stl with boundarie codes	Zymon	enGrid	31	August 29, 2011 14:40
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 15:09

All times are GMT -4. The time now is 03:28.