 |
 |
 |
|
|
|
[Sponsors] | ||||
May 13, 2014, 17:36
|
Inlet on cylinder wall ICEM
|
#1 |
|
New Member
Praveen Srikanth
Join Date: Jul 2012
Location: West Lafayette, IN
Posts: 23
Rep Power: 14  |
Hey,
I am trying to create a geometry of a cylindrical capillary where the top and the bottom are open to the atmosphere. I need to have an inlet on the side walls of the capillary. I am not sure how to do this with ICEM for a 3D geometry. I just want an approximate circular patch on the wall which can act as an inlet. I am using OpenFOAM for solving it and so the method has to work with that. Thanks a lot |
|
|
|
|
 |
| Tags |
| cylinder, icem, inlet, mesh 3d, openfoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 18:11 |
| Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
| UDF for wall slipping | HFLUENT | Fluent UDF and Scheme Programming | 0 | April 27, 2011 13:03 |
| Splitting inlet of a cylinder into two parts | Robert | FLUENT | 0 | May 23, 2008 04:17 |
Linear Mode
