 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Cutcell meshing quality issue |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 29, 2014, 06:11
|
Cutcell meshing quality issue
|
#1 |
|
New Member
SIVAKUMAR
Join Date: Jul 2013
Location: coimbatore
Posts: 13
Rep Power: 13  |
I have done a cutcell mesh using ansys workbench mesher. i have orthogonality issue near the corner( i have attached the image below).my orthogonality quality is 0.13 and skewness is 0.99.there is no problem in my inflation layer.please help me
1.JPG 2.jpg 3.jpg 4.JPG icem geo channel.zip |
|
|
|
|
|
April 29, 2014, 06:17
|
|
#2 |
|
New Member
SIVAKUMAR
Join Date: Jul 2013
Location: coimbatore
Posts: 13
Rep Power: 13 |
is there any other method better than this cutcell mesh....i heard hybrid mesh is not good for external flow analysis. my friend told me hexa core and cutcell mesh are better one for this type of geometry
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Increase Quality of Meshing | afdhal7 | ANSYS Meshing & Geometry | 1 | November 25, 2012 23:14 |
| ANSYS Meshing - DC Mesh Quality | alven299 | ANSYS Meshing & Geometry | 5 | July 19, 2010 12:34 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 12:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 12:08 |
Linear Mode
