 |
 |
 |
|
|
|
[Sponsors] | ||||
March 27, 2014, 11:45
|
Creating named sections
|
#1 |
|
New Member
Join Date: Mar 2014
Posts: 2
Rep Power: 0  |
Hi,
I am simulating flow over an airfoil in ANSYS. I have created my geometry and completed the meshing. All that is now left to do is created named sections (for inlet, airfoil, outlet etc) and then move on to FLUENT. However, when I create these named sections, the 'airfoil' never becomes available to select in fluent when looking at boundary conditions - whilst inlet, outlet, upper and lower wall are viewable. Has anybody else had this problem before and know the issue? I created a 3D curve by importing coordinates for my airfoil. Thanks |
|
|
|
|
 |
| Tags |
| airfoil, ansys, creating named sections |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 06:37 |
| [ANSYS Meshing] Creating named selections in ANSYS | ejayalv123 | ANSYS Meshing & Geometry | 3 | March 18, 2018 11:14 |
| [OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 12:39 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 21:50 |
Linear Mode
