 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] How could I named too many surfaces as wall? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 24, 2014, 17:40
|
How could I named too many surfaces as wall?
|
#1 |
|
New Member
Azadeh Saeedi
Join Date: Mar 2014
Location: Canada
Posts: 23
Rep Power: 12  |
Hi everybody,
I Imported a Part consist of the 3 bodies into DM in ansys workbench 14.5 for meshing and doing fluid analysis in fluent. my geometry consists of too many complex surfaces inside which I want them to be considered as wall except for 3 of them. My question is that as I import my geometry into design modeler there is no surface shown in the tree, so how can I select them and named them? should I select them by hand? they are too much around 500 surfaces. I really appreciate your help. Thanks |
|
|
|
|
|
| Tags |
| ansys meshing, design modeler, named selections |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Add a "sink term" in the cells near the wall surfaces in Eulerian approach | asal | Fluent UDF and Scheme Programming | 1 | September 11, 2014 16:05 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 10:28 |
| Thin Wall Heat Transfer BC for rhoSimpleFoam | swahono | OpenFOAM Running, Solving & CFD | 12 | October 4, 2013 12:49 |
| Error in recompiling the solver | m.maneshi | OpenFOAM Running, Solving & CFD | 0 | August 28, 2010 15:14 |
| Influece of wall velocity in the main flow | marvin | CFX | 0 | March 22, 2008 03:05 |
Linear Mode
