[ICEM] .TIN file to IGES

amrinder703 · March 21, 2014, 17:47

Hello All

I amtrying to export my .tin file to iges but i try use file->export->iges
instead saving the file ICEM ask for location to open file. I am confuse, is it a bug or just happening in my computer. I tried some other computer and it happened same there. Anyone also had the same problemor know solution.?

Thanks
Amrinder Singh

diamondx · March 23, 2014, 01:29

it's asking for the tin that you want to convert...

amrinder703 · March 23, 2014, 10:02

Thank you so much diamond, It worked. I am being dumb.

In my model i have split surfaces and i tried built topolgy but it was not succefull in joining all surfaces, any suggestions on that diamond.

thanks once again

Rajan Bhandari · May 17, 2018, 03:51

Quote:

Originally Posted by diamondx

it's asking for the tin that you want to convert...

Can you explain me why I get this error message when I load my geometry?
"Tetin file Tshape.tin does not exist".. I tried to open .igs file.

Rajan Bhandari · May 17, 2018, 04:09

Quote:

Originally Posted by Rajan Bhandari

Can you explain me why I get this error message when I load my geometry?
"Tetin file Tshape.tin does not exist".. I tried to open .igs file.

How do I create that?

March 21, 2014, 17:47	.TIN file to IGES	#1
amrinder703 New Member Amrinder Singh Join Date: Oct 2012 Posts: 10 Rep Power: 14	Hello All I amtrying to export my .tin file to iges but i try use file->export->iges instead saving the file ICEM ask for location to open file. I am confuse, is it a bug or just happening in my computer. I tried some other computer and it happened same there. Anyone also had the same problemor know solution.? Thanks Amrinder Singh

March 23, 2014, 01:29		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 29	it's asking for the tin that you want to convert... __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

March 23, 2014, 10:02	Thank you so much diamond	#3
amrinder703 New Member Amrinder Singh Join Date: Oct 2012 Posts: 10 Rep Power: 14	Thank you so much diamond, It worked. I am being dumb. In my model i have split surfaces and i tried built topolgy but it was not succefull in joining all surfaces, any suggestions on that diamond. thanks once again

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 04:30
what is swap4foam ??	AB08	OpenFOAM	28	February 2, 2016 02:22
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 17:02
friction forces icoFoam	ofslcm	OpenFOAM	3	April 7, 2012 11:57
2.0.x on Mac OSX	niklas	OpenFOAM Installation	74	March 28, 2012 17:46