|
[Sponsors] |
March 3, 2014, 12:44 |
Curve mesh setup, independent patch
|
#1 |
New Member
LOTFI OULD ROUIS
Join Date: Jan 2014
Location: Canada
Posts: 23
Rep Power: 12 |
Hi People,
Could anyone tell me why does the inflation cuve setup doesn't work with the patch independent meshing please? (Fig.1 and fig.2 which is a zoom of fig.1). Suggestions would be really appreciable Thank you very much, |
|
March 7, 2014, 10:40 |
|
#2 |
Senior Member
|
hope you have solved this issue already, otherwise I would suggest that this approach only work with patch dependent. that is why you are getting those inflation...
If yousolved this issue, please share your approach.!! regards julio Méndez |
|
Tags |
airfoil, dependent, independent, inflation, refinement |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] periodic faces not matching | Aadhavan | ANSYS Meshing & Geometry | 6 | August 31, 2013 12:25 |
Can I make a copy of a patch mesh and move it? | bigphil | OpenFOAM Programming & Development | 0 | October 13, 2010 11:29 |
[mesh manipulation] Using createPatch in place of couplePatches | sripplinger | OpenFOAM Meshing & Mesh Conversion | 8 | November 13, 2009 08:14 |
Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 07:51 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |