|
[Sponsors] |
February 19, 2014, 07:39 |
Hex vs Prism vs Tet
|
#1 |
Senior Member
Mr CFD
Join Date: Jun 2012
Location: Britain
Posts: 361
Rep Power: 15 |
Hello all,
I've come to a point in my CFD modelling where I need to refine my mesh for sensitivity analysis. I'm reading up on Hex vs Prism vs Tet (my solver is Ansys CFX if that helps). Are there any published papers who have compared Hex vs Prism vs Tet for a given simulation? What's the general guidelines concerning Hex vs Prism vs Tet? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face | A.A. | OpenFOAM Meshing & Mesh Conversion | 41 | June 26, 2020 08:06 |
[Other] mergeMatchPairs with arcs | vainilreb | OpenFOAM Meshing & Mesh Conversion | 1 | August 5, 2013 09:11 |
[blockMesh] apparently the mesh doesn't want to be created in one direction | Maxime Thomas | OpenFOAM Meshing & Mesh Conversion | 1 | August 18, 2012 07:05 |
[blockMesh] Blockmesh error - 2D scramjet | ishaninair | OpenFOAM Meshing & Mesh Conversion | 7 | March 18, 2011 01:14 |
CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 03:34 |