 |
 |
 |
|
|
|
[Sponsors] | ||||
February 11, 2014, 06:07
|
Surface roughness expansion
|
#1 |
|
New Member
magnus nytun
Join Date: Sep 2012
Posts: 9
Rep Power: 14  |
Hi
I have a 2D diffuser that is 6 meters long and covered with roughness elements along the floor. These roughness have the same geometry and spacing between them, but are in mm scale, so it becomes very tedious to draw them all. Does anyone know a way to just draw a small fraction of the geometry and then expand this gemoetry along the total length of the floor? Also may is it possible to add roughness using coordinate files? Thanks |
|
|
|
|
 |
| Tags |
| coordinate file, diffusers, expanding, roughness |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surface Roughness | Magnus123456 | FLUENT | 0 | January 22, 2014 11:32 |
| Surface Roughness Laminar Flow | cmh | OpenFOAM Pre-Processing | 0 | July 10, 2013 08:19 |
| Airfoil surface roughness | CMurphy | ANSYS | 2 | January 14, 2012 01:25 |
| Setting a surface roughness on a wall | Sandile Peta | FLUENT | 3 | February 1, 2006 09:14 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |
Linear Mode
