Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] Suggestions regarding meshing of a centrifugal impeller

Updated Threads

Reply

Search this Thread

January 31, 2014, 02:22	Suggestions regarding meshing of a centrifugal impeller	#1
S.Tushar New Member Tushar Join Date: Mar 2012 Posts: 6 Rep Power: 14	Hi I am trying to mesh a centrifugal pump's impeller in ICEM. I have started with a simplified geometry without the back and front fluid volumes. Being a novice to ICEM I am facing a lot of problems, for example I end up with holes in the surface mesh while meshing. I have tried creating blocks to make a structured mesh but as the vanes are curved backwards, I don't think its an easy task to block such geometry. Would greatly appreciate if someone experienced can help me in this regard. Thanks

Reply

Tags

icem, pump mesh

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Meshing Centrifugal Impeller	Bellmo	ANSYS Meshing & Geometry	8	November 27, 2018 14:02
Centrifugal Pump Impeller design	invincible328	Main CFD Forum	27	September 21, 2014 11:59
[GAMBIT] influence between angle in impeller blade and centrifugal pump performance	barak182	ANSYS Meshing & Geometry	2	August 18, 2010 04:07
Separated Regions of Centrifugal Impeller	Suzzn	CFX	0	February 27, 2010 12:05
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 12:09

All times are GMT -4. The time now is 11:00.