[ANSYS Meshing] How to generate the falling box mesh

DESOUZADACOSTA · January 27, 2014, 17:06

Hi All,
My doubt is not complicated.
I want to generate the mesh for the 2D falling box as in the figure using the ansys meshing.
Any comment is very welcome.
Alex

maccheese · March 19, 2018, 10:25

Hi,

I am interested in how to create this mesh as well. I manage to create a mesh quite similar with the inflation method, but I need the mesh as a choosable part in ANSYS setup (like in the falling box tutorial, where the mesh around the box gets assigned dynamic mesh properties). So how do I do that?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?	jash	ANSYS Meshing & Geometry	19	July 23, 2013 19:48
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 04:52
Meshing aifoil in ICEM	student123a	ANSYS Meshing & Geometry	13	December 8, 2010 11:40
[blockMesh] generate a graded pipe mesh.	jenright	OpenFOAM Meshing & Mesh Conversion	0	August 22, 2009 09:58
generate different mesh in CFX_MESH	Eric	CFX	0	June 23, 2006 10:09

March 19, 2018, 10:25		#2
maccheese New Member Join Date: Mar 2018 Posts: 24 Rep Power: 8	Hi, I am interested in how to create this mesh as well. I manage to create a mesh quite similar with the inflation method, but I need the mesh as a choosable part in ANSYS setup (like in the falling box tutorial, where the mesh around the box gets assigned dynamic mesh properties). So how do I do that?