Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

Geometry

Updated Threads

Reply

Search this Thread

December 24, 2013, 05:17	Geometry	#1
Amit Yadav New Member UTTAR PRADESH Join Date: Oct 2013 Posts: 1 Rep Power: 0	When Importing the ellipses from the catia to ICEM and then lofting , I am getting the correct geometry but when I am re-opening it after saving it as a project a lot of surface cracks appear on the surface. Even each ellipse is imported in two halves and not as one complete ellipse. kindly suggest some solution to this problem?

Reply

Tags

catia v5, ellipse, icem 14.0, import geometry

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Question about Geometry vs. Meshes	EphemeralMemory	ANSYS Meshing & Geometry	2	December 8, 2016 14:02
[ANSYS Meshing] need to convert a cell based geometry into STL or CGNS	kamran_kibria	ANSYS Meshing & Geometry	0	September 15, 2011 06:14
Reg difficulties in meshing the geometry...Urgent	arunraj	ANSYS Meshing & Geometry	0	August 27, 2011 00:25
[snappyHexMesh] SnappyHexMesh meshes inside and outside of an STL geometry	villier	OpenFOAM Meshing & Mesh Conversion	17	June 15, 2010 20:51
[GAMBIT] import terrain geometry	cfdworker	ANSYS Meshing & Geometry	2	May 24, 2009 22:40

All times are GMT -4. The time now is 04:04.