 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Move a Line to an Exact Coordinate |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 10, 2013, 04:39
|
Move a Line to an Exact Coordinate
|
#1 |
|
New Member
THC
Join Date: Dec 2012
Posts: 3
Rep Power: 13  |
In DesignModeler where I created a line, in the Detail View (located at the lower left panel), it show the X coordinate of the line as 5.5051 mm. What I want is the line to be exactly at 5.5000 mm, but I was unable to change that value in the Detail View (the box is greyed-out).
Is there any way I can change the X (and Y) coordinate of a line to the exact location I want or the length of the line? I only know how to create a line by drawing it with a mouse cursor, which ended up giving me not so accurate location and line length. Thanks in advance for the help! |
|
|
|
|
|
| Tags |
| coordinate, line, move |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is internalField(U) equivalent to zeroGradient? | immortality | OpenFOAM Running, Solving & CFD | 7 | March 29, 2013 02:27 |
| [Gmsh] Layers in a curved surface | Artex85 | OpenFOAM Meshing & Mesh Conversion | 1 | December 18, 2011 09:51 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 13:43 |
| errors | Fahad | Main CFD Forum | 0 | March 23, 2004 14:20 |
| Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 15, 2003 00:19 |
Linear Mode
