 |
 |
 |
|
|
|
[Sponsors] | ||||
October 17, 2013, 06:18
|
Problem in Edge meshing
|
#1 |
|
Senior Member
Daniel
Join Date: Mar 2013
Location: Noshahr, Iran
Posts: 348
Rep Power: 21  |
Hello guys
I am trying to mesh a converging channel with a slender obstacle inside it. (as you can see in the attachment) My problem is with the edges which have been numbered in the pictures. What I want to do is merging edges 1 and 5 and make the merged edge parallel with edges 2 and 3. Currently edges 4 and 5 are following each other and I can not set the node number on them independently. thanks in advance regards |
|
|
|
|
|
October 17, 2013, 07:45
|
|
#2 |
|
Senior Member
Daniel
Join Date: Mar 2013
Location: Noshahr, Iran
Posts: 348
Rep Power: 21 |
I have figured it out.
It was the matter of merging vertices. best wishes |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] 2-Way FSI meshing problem using ANSYS 13 workbench | john881129 | ANSYS Meshing & Geometry | 0 | January 9, 2012 02:19 |
| [snappyHexMesh] Problem Meshing a V-notch Weir with snappyHexMesh | kflora | OpenFOAM Meshing & Mesh Conversion | 11 | December 19, 2011 02:58 |
| Problem with segment surface and meshing | Silmaril | ANSYS Meshing & Geometry | 1 | October 13, 2011 17:42 |
| [ICEM] Mutiple Edge problem | angierain | ANSYS Meshing & Geometry | 4 | August 3, 2011 12:38 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 02:07 |
Linear Mode
