 |
 |
 |
|
|
|
[Sponsors] | ||||
August 10, 2013, 14:59
|
inquiry about shell meshing
|
#1 |
|
Senior Member
mohamed khedr emam
Join Date: Oct 2011
Location: Egypt
Posts: 121
Rep Power: 15  |
Dear experts,
I'm using shell meshing to mesh wind turbine blade , the problem is that the curvature resolution depend on mesh size. If i reduce the mesh size to capture the curvature details, specially at leading edge, the elements reach to 11 million (with the prism). I'm used AllTri Patch dependent or independent Any recommendation Thanks in advance |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Shell meshing with respect line elements | diamondx | ANSYS Meshing & Geometry | 1 | May 17, 2013 18:43 |
| [Commercial meshers] Meshing open shell in ICEM | Jenny_W | OpenFOAM Meshing & Mesh Conversion | 0 | June 7, 2012 18:54 |
| [ICEM] Not getting shell meshing | Far | ANSYS Meshing & Geometry | 2 | May 17, 2012 15:30 |
| shell meshing methods in ICEM-CFD | jkatz | Main CFD Forum | 0 | September 18, 2008 12:43 |
Linear Mode
