 |
 |
 |
|
|
|
[Sponsors] | ||||
August 8, 2013, 20:04
|
ICEM ignores curve mesh number
|
#1 |
|
Senior Member
Ehsan Asgari
Join Date: Apr 2010
Posts: 473
Rep Power: 18  |
Dear Friends,
I am trying to create a 2d tri mesh in ICEM. I have created an initial grid but when I try to increase node counts, ICEM simply ignores it overriding it by previous counts. I have tried to delete entire elements and nodes but it does not make any changes. My steps are as follow: 1-"Curve Mesh Setup" and setting node counts. 2-"Global Mesh Setup"-->"Shell Meshing Parameters"-->patch dependent option 3-Compute Mesh"-->"Compute". As you can see, I am a newbie in unstructured mesh and I appreciate any help. Thanks |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] non-smooth mesh | Svensson | OpenFOAM Meshing & Mesh Conversion | 11 | January 18, 2012 10:13 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 10:01 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
| varying curve mesh spacing at icem surface-mesh? | mirko_r | ANSYS Meshing & Geometry | 6 | January 14, 2010 14:23 |
| ICEM 10 mesh question | DAK565656 | CFX | 6 | May 8, 2007 13:16 |
Linear Mode
