[ANSYS Meshing] Problem: Blayer 2d inflation layer -- CFD Online Discussion Forums

March 27, 2013, 06:12

Problem: Blayer 2d inflation layer

j_h_86

Member

Johannes Ringborn

Join Date: Nov 2012

Posts: 40

Rep Power: 14

Dear all,

I want to create an inflation layer in a 2D Tri-mesh. Therfore I turned on the Blayer 2d option and specified the curve parameters for the curve, which should be inflated.

This works fine except for the beginning and for the end of the curve, where other orthogonal curves meets the inflated BL (see attached image).

Any help would be appreciated.

Best regards

Attached Images

quest2.jpg (92.3 KB, 42 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Inflation layer	federico.bruni	ANSYS Meshing & Geometry	2	October 29, 2012 09:25
[snappyHexMesh] Boundary layer generation problems	ivan_cozza	OpenFOAM Meshing & Mesh Conversion	0	October 6, 2010 14:47
[GAMBIT] 3D Boundary Layer problem	Harald D	ANSYS Meshing & Geometry	0	April 16, 2009 05:54
Flat plate boundary layer problem	student	Main CFD Forum	3	May 21, 2007 14:10
2d axysymmetric inflation layer	justin	CFX	5	April 12, 2007 09:28

All times are GMT -4. The time now is 21:45.