[ANSYS Meshing] problem about the geometry and meshing of the airfoil

yileihe1989 · February 10, 2013, 23:38

Hey
When I was trying to establish the mesh, I ran into this problem: some abnormal mesh appeared.Does somebody know why this happened?

And the other thing is what the green point and the arrow stand for in the trailing edge of the airfoil. I imported the airfoil from coordinate file and the begin point is (1,0).

Thanks!

jrunsten · February 11, 2013, 05:00

Not sure about the weird mesh. Supply an archive of the project if you want someone to look at it.

The second question is easier. It is just a coordinate system for the 3d curve

nauman55 · February 24, 2013, 07:18

the problems seems with a bad vertex or curve association check that out.
regards

February 24, 2013, 07:18	Re	#3
nauman55 Member nauman hashmi Join Date: Jun 2012 Posts: 54 Rep Power: 14	the problems seems with a bad vertex or curve association check that out. regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Problem with meshing a complex Geometry (Hex)	fluent_beiyo	ANSYS Meshing & Geometry	8	April 26, 2014 05:55
Problem Importing Geometry ProE to CFX	fatb0y	CFX	3	January 14, 2012 20:42
[ANSYS Meshing] Help - Meshing 2 Surfaces On A 2D Geometry	Ali_M	ANSYS Meshing & Geometry	4	March 29, 2011 04:01
[Gmsh] Problem meshing an imported geometry	Alicia	OpenFOAM Meshing & Mesh Conversion	0	March 30, 2010 05:53
Problem meshing turb. blade tip clearance geometry	Balu	FLUENT	0	June 7, 2008 22:10

February 11, 2013, 05:00		#2
jrunsten Senior Member Josef Runsten Join Date: Jul 2010 Location: Gothenburg, Sweden Posts: 188 Rep Power: 24	Not sure about the weird mesh. Supply an archive of the project if you want someone to look at it. The second question is easier. It is just a coordinate system for the 3d curve