[ICEM] Normal to edge split

Bollonga · February 9, 2013, 05:23

Is there a way to split a block from prescribed point in the normal direction to the edge?
Icem only allows to do it in one of the three cartesian direction, as far as I know.
That would help me a lot in making simpler blocks in a faster way.

Thanks!

Far · February 9, 2013, 07:04

you can adjust your vertices later with vertex setting commands

Bollonga · February 9, 2013, 08:32

Quote:

Originally Posted by Far

can you adjust your vertices later with vertex setting commands

I know, but I wanted to know if there was a way to do it directly. I'll do it modifing vertices then.

February 9, 2013, 05:23	Normal to edge split	#1
Bollonga Senior Member Francisco Join Date: Mar 2012 Location: Spain Posts: 273 Rep Power: 15	Is there a way to split a block from prescribed point in the normal direction to the edge? Icem only allows to do it in one of the three cartesian direction, as far as I know. That would help me a lot in making simpler blocks in a faster way. Thanks!

February 9, 2013, 07:04		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	you can adjust your vertices later with vertex setting commands Last edited by Far; February 9, 2013 at 08:49.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 07:09
Actuator disk model	audrich	FLUENT	0	September 21, 2009 08:06
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 02:07
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
NACA0012 geometry/design software needed	Franny	Main CFD Forum	13	July 7, 2007 16:57