[ICEM] how to improve mesh quality around sharp edge?

foolboy007 · January 21, 2013, 23:07

This is the tip of a nozzle. I have to generate the prism layer to get y+~1.
without prism, the overall mesh quality and skewness are really good.
however, after generating prisms, the quality got really poor.
I found most of worst mesh grids are around the tip of the nozzle.

Could any body tell me how to improve the quality?
If necessary, I can modify the sharp edge and make a round fillet.

Far · January 23, 2013, 12:57

Do you have access to Simon's Tip and tricks 2010? There are very useful hints.

It is always good idea to share project at earliest

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 10:38
[ICEM] Improve prism mesh at trailing edge	siw	ANSYS Meshing & Geometry	5	August 21, 2011 00:56
Improve Mesh quality - airfoil simulation	Lukas84	STAR-CCM+	4	July 6, 2010 11:07
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 20:43
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 02:07

January 23, 2013, 12:57		#2
Far Senior Member Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,558 Blog Entries: 6 Rep Power: 54	Do you have access to Simon's Tip and tricks 2010? There are very useful hints. It is always good idea to share project at earliest