 |
 |
 |
|
|
|
[Sponsors] | ||||
December 18, 2012, 10:00
|
mesh at the corner: bad quality
|
#1 |
|
Senior Member
Join Date: Nov 2012
Posts: 171
Rep Power: 14  |
Hi All,
When I generate the mesh for a square chamber using tetra/prism mesh, I found that the cells at the corners of two walls always have bad quality (as shown in the attached figure). Does anybody know how to improve the quality of the mesh there? Thanks. |
|
|
|
|
|
December 18, 2012, 12:45
|
|
#2 |
|
Senior Member
Bruno
Join Date: Mar 2009
Location: Brazil
Posts: 277
Rep Power: 21 |
Try using smoothing the surface mesh using the Laplace algorithm (set the volume elements to 'Float') several times, then regenerate the volume mesh using the Delaunay method.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
| [ICEM] Tips for 3D tetra mesh quality for Fluent transient run. Rotary Engine | Catthan | ANSYS Meshing & Geometry | 0 | June 18, 2012 13:46 |
| [snappyHexMesh] mesh quality control and fix | tachyon_me | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2009 13:48 |
Linear Mode
