[ANSYS Meshing] Problem of Meshing a orifice within a very thin pipe -- CFD Online Discussion Forums

December 8, 2012, 16:37	Problem of Meshing a orifice within a very thin pipe	#1
justeyong New Member Yiyuan YONG Join Date: Dec 2012 Posts: 3 Rep Power: 13	Hi there, I'm simulating the flow in orifice meter. The diameter of the pipe is 12.5mm, and the orifice diameter is 4mm. The following figure shows the geometry of the orifice. When I doing the mesh, I separated the body into serval small rectangular parts. However, one of the rectangular is very small. How do I mesh that one?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Meshing U-shaped cylindical pipe	stainboy	OpenFOAM Meshing & Mesh Conversion	0	November 11, 2012 22:01
Meshing problem Gambit-fluent	ajay	FLUENT	3	January 28, 2011 02:42
meshing at a pipe intersection	cyn	FLUENT	0	December 20, 2006 03:16
GAMBIT meshing problem	Gauthier Lambert	Main CFD Forum	1	August 3, 2000 10:22
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 22:31

All times are GMT -4. The time now is 19:39.